The Send to GPS command sends the all of the waypoints, routes, and/or tracks in the file to your GPS receiver.
Tip
- To send all of the items in the file to your GPS, use the Send to GPS command.
- To send only a particular set of items to your GPS, select them and use the Send Selected to GPS command.
To send data to your GPS, do one of the following:
- On the , click .
- On the main toolbar, click the
Send to GPS button.
The Send to GPS dialog will appear. Check the box next to the kinds of GPS data you want to send to your GPS, and click OK.
The Progress dialog will appear and show the time remaining for the GPS transfer.
After the GPS transfer is complete, your GPS sent to your GPS. You may need to switch to a different page on your GPS receiver's screen to refresh its data display. Some GPS receivers only show the 10 waypoints nearest to your location by default. Consult your GPS manual for instructions on showing all the GPS data on your GPS receiver's screen.
If an Error Occurs:
- If an error message appears before the Progress dialog appears, read GPS Errors.
- If an error message appears during the GPS transfer, read GPS Transfer Errors.
- Turn the GPS off and back on again to reset the GPS interface before attempting any further GPS actions.
